Vinyl Instructions

Inside your envelope you will have

1. Vinyl decals
2. Transfer paper 

Following the instructions below step by step will assure a product that looks great

1. Prepare your item that the vinyl will be applied to, make sure it is clean dna dry

2. Lay your vinyl on a flat surface, like a table or desk

3. Cut the transfer paper to the size of your vinyl decals

4. Remove the top layer of the transfer paper, you will have a clear sticky sheet to work with

5. Stick the transfer paper smoothly over the top of your vinyl decal, assuring there is no bubbles or creases in it

6. Run your fingers over the letters assuring that they have stuck to the transfer paper, you may have to do this a couple of times for fancier and thinner fonts

7. Slowly peel away the transfer paper, making sure that each letter is attached to it

8. Position the transfer paper on your item

9. Run your fingers over the lettering again to get them to stick to the item, you may have to do this a couple of times for fancier and thinner fonts

10. Slowly peel away the transfer paper from the vinyl lettering, as slowly as possible to avoid the letters from ripping, we would also advise to peel at an angle

11. Enjoy your new product, and show off your hard work by tagging us in your photos!